Alpine ACTIVE VIEW HCE-C305R, Руководство пользователя, Страница: 21 / 39

ALPINE HCE-C305R_EN 68-23120Z52-A (A5)
19
-EN
a
he
in
ck
e
th
r
h.
e
ngle
<Attachment angles>
Camera height Angle (degrees)
(from horizontal plane)
inch mm
51.2 1300 40 - 59
47.2 1200 38 - 57
43.3 1100 35 - 55
39.4 1000 33 - 52
35.4 900 30 - 49
31.5 800 27 - 46
27.6 700 24 - 42
23.6 600 21 - 38
19.7 500 18 - 33
17.7 450 16 - 30
If the unit is not installed within the designated
angle, calibration cannot be executed correctly.
Camera installation height
Lowest: 430 mm (16.9”)
Highest: 1300 mm (51.2”)
Largest left and right offset
400 mm (15.7”) from the centre of the vehicle
both in the left and right directions
Depth
A maximum of 300 mm (11.8”) from the tip of
the rear bumper
Install the camera as outward as possible to ensure
the detection range of 180°.
Provide enough clearance for proper trunk and door
closure without making contact with the camera.
Also, ensure that the camera cable is not being
pinched or damaged.
Attach the camera in a position where it does not
touch the license plate.
Make sure there are no objects protruding between
the camera and bumper (wipers, rear-side racks,
etc.).
Do not install the camera near the reverse lamp.
If any part of the vehicle body blocks the camera
coverage area, detection of that area will not be
possible.
•
e
e
e
•
•
•
•
•
•
3
Installing the camera and the camera
mounting bracket to the car.
Making holes for the camera cable
Attaching the Camera
Angle adjustment
screw
Make sure that the ALPINE
logo of the camera is
facing up.
e
e
(1) Drill a 13 mm (1/2”) hole at the
mounting location for the camera
cable. Drill 2.5 mm (3/32”) holes for
mounting the bracket. Apply touch-up
paint as necessary.
(2) Make sure the mounting surface is
clean of debris, dirt, etc.
(3) Attach the camera to the mounting
bracket
H
with the supplied
adjustment screws.
(4) Make sure the camera is facing directly
behind the vehicle. It’s horizontal
viewing angle should be at 90° to
the rear bumper. Adjust its vertical
viewing angle to about 45° to the
ground behind the vehicle.
(5) Pull the camera cable inside the car
through the 13 mm (1/2”) hole made
in step (1).
(6) Peel off the protective sheet covering
the adhesive strip on the bracket
H
.
Attach the bracket to the surface just
cleaned.
If mounting to plastic, use a self-tapping screw to
attach the camera bracket
K
.
•