ALPINE HCE-C305R_EN 68-23120Z52-A (A5)
15
-EN
Camera Operation
VIEW
SET.
Operation is carried out by pressing the switch, or
shifting the gear lever.
The following settings may be required depending
on the connected navigation/monitor.
Rear camera connection: ON setting
Setting to ON is required to display the camera
image on the navigation/monitor.
Camera guidelines display: OFF setting
This camera system has its own, calibrated
guidelines. It is not necessary to display the
guidelines found in the navigation/monitor
system being used.
Refer also to the owner’s manual of the product to
connect.
Turning the Rear Camera On
and Off
Displaying the rear image by
shifting the gear lever
1
Shift the gear lever to the reverse
position (backing up).
The video image behind the car and the
audible warnings depends upon the gear
shift position.
2
If you shift the gear lever to a position
other than reverse (backing up), the
monitor returns to the previous screen.
Refer also to the Owner’s Manual of the connected
monitor/navigation system.
Be sure to also check behind and around the car
visually. Use the camera image to assist in showing
conditions behind and around the car.
Depending on where the unit is installed, actual
conditions may differ from the displayed image.
•
•
•
•
•
•
Changing the Rear Image
Configuration
1
Press
VIEW
.
The image configuration changes every time
VIEW is pressed.
Rear View
Panorama View
Corner View
Ground View