Alpina EHT 600 PROXH 600E-PRO, Руководство по эксплуатации

Страница: 8 / 11

GB-2
Attention: Danger! Rotating machinery.
8. The hedge trimmer should always be held with
both hands.
9. Before using the equipment clear the working
area of any foreign objects and be aware of
foreign objects during operation of the machine!
If the machine becomes jammed e.g. by thick
branches, switch off and disconnect the ma-
chine from the mains socket before investigating
and rectifying the cause of the jam. Take special
care when switching the machine on again.
10. Check the fl ex and all connections for any visible
faults before using the machine (plug discon-
nected). Do not use a faulty fl ex.
11. Keep the fl ex away from the cutting area.
12. Do not use the trimmer in wet weather and do not
use it to cut wet hedges.Do not wash down the
device with water. Do not use any high-pressure
cleaning devices or steam jet devices for cleaning.
13. Carry the trimmer by the handles provided and
keep hands away from the cutting blades.
14. In line with agricultural Trade Association Regu-
lations only persons over the age of 17 may work
on their own with electric hedge trimmers. Use is
permitted for persons over 16 years if the work is
carried out under the supervision of adults.
15. We would recommend that safety clothing is
worn during the work and that eyes, ears, hair,
hands and feet are fully protected. Protective
gloves should also be worn.
16. Ensure that the motor of your hedge shears can
not be switched on by mistake when you put it
down after work or when you are going to clean the
device. Never forget to unplug the mains supply!
17. Check the cutting unit regularly for damage and
if damage is discovered, the cutting unit should
be properly repaired.
18. Be aware of your responsibility as user towards
third parties in the working area.
19. The trimmer must be properly checked and serv-
iced. If the blades get damaged they should only
be exchanged in pairs. In the event of damage
from impact, specialist’s inspection is essential.
20. Only use extension cords that are approved for
outdoor use and that are not lighter than rubber
tube cords type H07 RN-F according to DIN/VDE
0282 with a diameter of at least 1.5 mm
2
. They must
be water spray protected. Damaged cables of this
unit are only to be replaced by a service station
designated by the manufacturer as special tools
are necessary. Equipment which will be used in
different outside locations should be connected
via residual current - operated current breakers.
21. Do not use the cable for purposes it has not
been designed for. Never carry a power tool at its
cable. Do not pull out the plug from the socket
using the cable. Protect the cable from heat, oil
and sharp edges.
22. Ensure that the equipment is stored safely af-
ter use in such a way that the blade cannot be
touched.
23. When using the equipment, hold it securely with
both hands, stand fi rmly and ensure that you have
suffi cient working space. There should be no
people, animals or objects within the working area.
Select the cutting height so that the blade does
not make contact with the ground and you can
operate the equipment from a secure position.
24. Take care when transporting the equipment (only
with blade cover!).
25. For initial use of the hedge trimmer we would rec-
ommend that in addition to reading the operating
instructions, you also seek a practical demon-
stration from an expert.
26. Always ensure that all protective devices and
handles are properly fi tted. Never attempt to use
an incomplete machine.
27. Never try to use an incomplete tool or a tool that has
been modifi ed in a way that has not been approved.
28. Do not allow children to use a power tool.
29. The use of the hedge trimmer is to be avoided if
other persons, above all children, are within the
working area.
30. Familiarize yourself with the working area and pay
attention to possible dangers which you might not
be able to hear due to the noise of the machine.
31. Always pay attention. Take care of what you do.
Do your work sensibly. Do not use a power tool if
you cannot concentrate.
32. ATTENTION ! Only use the accessories or attach-
ments shown in the Operating Instructions. The
use of other add-on tools and accessories may
set up the risk of injury for you.
33. Have your power tools repaired by an appro-priate-
ly qualifi ed electrician only. This power tool complies
with the applicable safety regulations. Repairs must
only be carried out by qualifi ed electricians using
original spare parts; otherwise, accidents may occur
to the user.
5. Before use
Mounting the bow-type handle (Fig. 1)
If there are screws fi xed to the mounting points, remove these
fi rst. Then, remove the shear protector and put the bow-type
handle from the front (as shown in Fig. 1) over the shearing
system, and put it into the relief of the hedge shears’ housing.
(If necessary, pull the lower ends of the handle slightly apart.)
Take care that you do not squeeze the two parts of the bow-
type handle.To fasten the bow-type handle screw the two
included screws through the openings in the handle into the
threaded holes of the housing and fasten them tightly.
Protection shield (Fig. 2)
If screws are fastened to the bottom plate, remove these.
Fasten the hand protector with the two included screws to
the bottom plate.
Power connection
The machine can only be connected to a single-phase a.c.
current connection. The machine is protectively insulated in
accordance with classifi cation II of VDE 0740. Before using
the machine ensure that the mains current agrees with the
operating voltage data on the machine’s identifi cation plate.
Power Circuit Breaker:
Machines which will be used in different outside loca-