PD9B01M0 1ST ISSUE 1/07/2019 16
1.12 Instruction for reporting information after maintenance
1.12.1
Instruction for reporting possible safety/flight concerns
The form in ANNEX B must be used by the owners to report safety of flight concerns found
during inspection/maintenance. Please copy that page, cut out along the marked borders
and send it to the Company contacts indicated in paragraphs A.2.
1.12.2
Manual Improvements and feedbacks
The form in ANNEX C must be used by the owners to report improvements or corrections to
this Manual. Please copy that page, cut out following the borders and send it to the
Company contacts, see paragraph A.2.
1.12.3
Aircraft assembly
In case it is necessary to disassemble or assemble the aircraft after or for transportation or
maintenance activities, follow the indications provided into ANNEX A (Aircraft Assembly
group).
1.12.4
Change in ownership
The form in ANNEX D must be used by the owners to report a change of address/ownership.
Please copy this page, cut out following the borders and send it to the Company contacts, see
paragraph A.2.
2 Inspections
Alpi Aviation considers the inspection schedule outlined below compulsory for safety operation on
the airframe and systems over an extended period of time.
The described servicing requirements pertain to operation in non-extreme climatic conditions.
✓
For all the prescribed Rotax engines, unless otherwise stated, it is compulsory to adhere to
maintenance requirements as listed in the latest revision/release applicable, at the time of
maintenance, in the Engine Operators Manual and Engine Maintenance Manual.
✓
For all the prescribed propeller types, refer to the latest revision/release applicable, at the time
of maintenance, of its Instruction Manual
.
2.1
Inspection panels
Inspection points that are not in plain view may be accessed through specific inspection panels or
fairings described below and shown in the ANNEX A (Fuselage Body group):
Inspection panels on wing underside - access to:
✓
aileron bell cranks;
-
cabin (main spar and torque box);
-
inspection of the wing tank drains;
-
flap actuation bar
✓
Tail cone underside inspection panel - access to:
-
Main structure frame/control cables;
-
elevator relay to control lever;
✓
Tail cone end-fairing access to:
-
elevator relay to control lever;
-
attachment of vertical stabilizer aft spar;
-
elevator pushrod.