Document N° :
F2-1.0/R80/F/EU
Pioneer 200
Flight Manual
Section: 4
Normal Operations
REVISION :
0
Dated: 20-04-2002
Sect : 4 -Page: 10 of 108
either system.
If drop is excessive, shut down & determine
the reason.
Switch No. 2 Ignition ON.
NOTE
During the check with one system only, the inactive sparkplugs may
tend to load up slightly. To clean plugs, run the engine with both
ignitions for a few seconds, then recheck the second system.
9
Power Check
Throttle to 550 RPM
Open the throttle fully & slowly to check the
maximum RPM being produced.
Wind conditions may effect, but as an average
5500 RPM should be seen.
NOTE
If the RPM is found to be more than 300 RPM lower than normal,
the engine should be examined to determine the reason.
10
Idle Check
Throttle to idle position & check that the engine
runs smoothly.
With too low an idle speed, or rough running,
the cause must be located & corrected to avoid
the potential for an in-flight stoppage
11 Carburettor
Heat
Check
(if applicable)
Throttle up to 4000 RPM
Pull out the Carburettor Heat Control & look for
an RPM drop.
Return the Carburettor Heat Control to the Full
IN or cold position.
