5
CONNECTIONS
The AT-304 receiver is supplied in a synthetic casing and must be powered by an external 10-24VDC power supply.
The PCB contains terminal connections for one relay output, 3 open collector status outputs, an "ARM" input and
the power supply.
AT-304 PCB equipped with Visonic PowerG 868Mhz receiver module and antenna.
ENROLLING TRANSMITTERS, KEYFOBS AND DETECTORS
For a transmitter, keyfob or detector to communicate with the AT-304 receiver, it must first be enrolled. A
maximum of 16 wireless devices can be enrolled.
1)
Open the casing so that the print is visible.
2)
No jumper should be placed over the pins on the PCB, not even over the TAMP pins!).
3)
Set dipswitch 1 on dipswitch 1-8 to ON, the green LEARN (OP12) LED will start to flash slowly.
4)
Now press the switch S1, the LEARN (OP12) LED will now flash rapidly.
5)
PowerCode:
Press the button on the transmitter, the keyfob or the tamper switch on a detector. The
device enrolls and the LEARN LED starts flashing slowly again.
PowerG:
Follow the steps in the manual of the PowerG device for the correct enrolment procedure. For
detectors, in most cases an “Enroll” button on the detector will have to be pressed until the LED on the
detector lights up yellow. There are also detectors that enrol directly when the batteries are installed. For
keyfobs you usually must press the * key until the LED on the keyfob lights up orange (amber). When the
device is enrolled, the LEARN (OP12) LED on the AT-304 will flash slowly again.
6)
Repeat steps 4 and 5 for the next transmitter or detector.
7)
When all transmitters and detectors have been enrolled, switch dipswitch 1 on dipswitch 1-8 back to OFF.
