Alphatech Slim IPDP - 01, Инструкция по установке и эксплуатации, Страница: 15 / 45

IPDP - installation and operating instructions
15
2 DoorPhone VoIP Operation
2.1 Signaling Overview
The IPDP signals an acoustic conditions they may occur during
operation. Another signaling can be done by means of red LED (placed under
microphone hole). You can listen the signaling samples in Nset setting
program.
Condition Tones Tone frequency LED
Line lifting up –▄–■–▀– 425-850-1275
Light
Line hanging up –▀–■–▄ 1275-850-425
Dark
Report after calling –▄–■–▀– 425-850-1275
Light
Notice about call end –■–■–■– 1275
Light
Parameter confirmation ––█––
Switch on (Reset) –■–▄–■– 1275-850-1275
Blink
Error (anything, if unsuitable)
–■–■–■–■–■–■–
425….
Empty memory (no progr. numb.)
–█–▄–■–▄–■–▄–
850-1275-1700…
Waiting to talk
-
-
Blinking
Is talk
-
-
light
2.2 Visitor at Door
The IPDP function is influenced by setting of IPDP parameters.
The DoorPhone buttons are provided by nameplates or positions of
persons inside the object. The incoming person will press the corresponding
button, the DoorPhone will lift up the VoIP canale neither immediately (the
button is not the first number from code lock), or with delay and dial the
programmed phone number thru VoIP, but dial number differs by choice mode,
which is set in the DoorPhone :
- Day/night mode = being the DoorPhone in Day mode, so it is always
dialing a number set in table 1, in Night mode, it is always dialing a
number set in table 2. . Switching is possible use manual (two codes)
or automatic (table "Day intervals") and here you can set the switch
to three day intervals for 7 days a week. To facilitate proper function
is to set the IP address of the NTP server and network settings so
that the DoorPhone IPDP should have access to the Internet. In
automatic mode, day / night mode is also possible to use a
temporary manual switch, which cancels the first passage of the next
automatic switching interval.