Heatmaster 2
17
hardare to allow the Mainboard to recognize this as a switching contact. Normally the pre-set 8 seconds
should be plenty. The setting should only be changes if there are problems with the Mainboard.
Display configuration
Important note in advance:
To use this feature a display must be connected to the data
cable. The display must also allow brightness adjustments.
Multiple displays will be able soon, for more information go to
Brightness during operation:
Here the brightness of the display lighting during operation can
be set.
Brightness in sleep mode
Here the display brightness in sleep mode can be set
(recommended setting: 0%)
Brightness of stand-by lighting
If no activity is detected, the display can be switched to stand-
by mode. We recommend reducing the brightness ion stand-by
mode.
Standby time
Here the period of time of inactivity after which the display will
go into stand-by mode can be set.
Fan configuration
Here the fan channel for which the settings will be made can be
Name
It is possible to name every fan channel individually. The name
may contain up to 255 characters made up of letters and
numbers.
Status
Sets the mode of the fan between: Inactive, not connected and
active
Speed monitoring
Here it can be set if the fan is equipped with a speed monitoring
feature. This is usually only the case i fit is equipped with a rpm
lead.
Fan switch-off in case of failure
If the fan is controlled by the Heatmaster to a target speed or
voltage, but does not send a signal back, this feature will prevent
the Heatmaster from trying to spin up the fan until the next
system start-up.
Action in case of fan failure
here different alarm levels can be set. If the fan is a system-
critical fan it is often useful to set an alarm or even system shut-down here.
Determine Min. / Max. speed
We recommend determining the minimum and maximum speed once per each fan to allow the Heatmaster 2
to determine the relevant data. If fluctuating values for maximum and minimum speed are to be expected, a
check after every start-up can also be set.
