Power Pong
User Manual
Page 33
6.
After removing all 16 screws, gently lift to separate the upper portion of the robot base with
the throw arm mounting assembly from the lower robot base. (Photos 5-19 and 5-20)
7.
Remove any balls in the lower portion of the robot base.
8.
Inspect/clean the lower portion of the robot base of any debris, dust, foreign objects, etc. as
needed.
9.
Examine the feed motor assembly and the gear assembly. Clear/remove any debris, dust,
dirt, foreign objects, etc. (See photo 5-20)
10.
When all assemblies are cleaned appropriately, re-assemble in reverse order.
Caution:
Do NOT use a powered screwdriver as you re-insert the screws. The screws are
inserted into plastic. To avoid stripping the plastic, only use hand screwdrivers.
5.5
Calibration
5.5.1
Checking Calibration
The robot comes pre-calibrated from the factory. To test calibration, perform the following:
Photo 5-19
Photo 5-20
Photo 5-18
