Alpha CXPS-C, Техническое руководство

Страница: 38 / 84

35 9400001-J1 Rev F
7.1.2 Setting the Anchors
First, review manufacturer's instructions before setting the anchor.
1. Drop the anchor into the drilled hole.
2. Insert the anchor setting tool and hit it with a hammer to expand the anchor until the collar of the setting tool
rests against the shoulder of the anchor.
7.2 Placing and Securing the Bays
7.2.1 Securing the bays to the floor
1. Place the bay in position over the anchoring holes (and the isolation pad if applicable).
2. Install the anchoring hardware for each anchor FINGERTIGHT.
3. Check that the bay is level front-to-back and side-to-side.
Figure 29 — Securing Power System to Concrete Floor
NOTE:
When installing two or more adjacent bays, install the inter-bay DC components per
section 7.4 before completing the final torquing of the anchor bolts.
4. Once the bay is level, tighten all bolts to the appropriate torque, supplied by the anchor manufacturer.
CAUTION!
It is extremely important that the bay be properly shimmed in order to prevent any frame
distortion. If the floor is not level, shims may be required.
Shims should be installed as close as possible to the anchoring hardware underneath
the bay. Shims can be installed on two corners, to level left to right and front to back.
• Standard slotted square shims are recommended.