8
GB
center. Never use any tool if its switch
cannot be turned off and on.
20. Important!
– For your own safety, use only accesso
ries and attachments which are listed in
the operating instructions or recommen
ded or listed by the tool manufacturer. The
use of any accessory or attachment other
than those recommended in the operating
instructions or catalogue may involve a
risk of injury for you personally.
21. Have repairs carried out only by a qua
lified electrician
– This electric tool complies with the perti
nent safety regulations. Repairs are to be
carried out only by a qualified electrician
or the user may suffer an accident.
22. Noise
– The noise level of this electric tool is
measured in accordance with EN 50144-1.
Noise at the workplace may exceed 85
dB(A). In this case, the operator must
wear ear-muffs or similar.
Keep these safety instructions in a safe
place.
Use
The soldering gun is designed for light-duty sol-
dering jobs, soldered electric connections,
model-making and poker-work.
Additional safety information
앬
Hold the heated soldering gun only by its
handle. Risk of burns!
앬
Put down the heated soldering gun only on
non-combustible and heat-resistant surfaces.
Risk of fire!
앬
The soldering tip coupling has to be secure.
Check before beginning your work.
앬
Keep the power cable away from the solde-
ring tip at all times.
앬
Do not stick down the ON/OFF button.
앬
In view of the high working temperatures
involved, you should use a suitable fixture to
secure the workpiece in position.
앬
The soldering tip becomes hot during use
and may cause burn marks, scorch marks
and - in the worst case - burn wounds and
fires if not used without proper care.
앬
Never dip the soldering tip into water, and
never hold the soldering tip under flowing
water.
앬
Wear safety goggles during soldering work.
Tin and flux spatter may cause eye injuries.
앬
Some flux materials give off unpleasant
vapors when heated. Make sure the work
area is well ventilated.
Operating instructions
앬
Every heating phase of a maximum 12
seconds must be followed by an OFF inter-
val of at least 48 seconds. In other words,
the soldering gun may only be used in inter-
mittent mode.
앬
Make sure that the parts to be soldered are
clean. Clean them in advance with steel wool
or fine sanding paper.
앬
Make sure that the soldering tip is tinned; if it
isn’t, use the supplied solder wire. Never use
a file to clean the soldering tip.
Wipe the soldering tip on a silicon sponge
and then tin it.
앬
Heat the joint and not the solder. Touch with
the soldering tip the parts you want to solder
so that both parts are uniformly heated. Add
a little tin solder to the joint.
앬
Withdraw the soldering gun carefully and
quickly without moving the parts you are sol-
dering.
앬
Do not use too much solder. Use only as
much solder as necessary.
앬
Take care not to overheat electric and elec-
tronic components.
앬
If you want to join wires together by solde-
ring, you should first tin their ends. Twist the
strands together, heat them and add a little
tin solder.
앬
The plastic tip can be used to repair objects
made of thermoplastic material (children’s
toys).
앬
The standard soldering tip can be used for
poker-work (burning motifs on wood and lea-
ther).
Technical data
Mains voltage
230 V ~ 50 Hz
Power rating
100 W
Heating phase
12 seconds
OFF phase
48 seconds
Light
0.25 A / 0.55 W
Totally insulated
쵭
Weight 0.625
kg
Anleitung LP 100 SPK 7 19.05.2005 11:04 Uhr Seite 8
