Alpha IP RTD 61001-N1, Инструкция по эксплуатации

Страница: 14 / 144

POL
RU
S
FIN
DA
N
SWE
NOR
ENG
14
Commissioning
ENG
1. Select the desired channel at the Alpha IP base station (see Alpha IP Base station
instructions).
2. Press the System key (A) of the Alpha IP base station for 4 seconds, until the LED
of the System key flashes rapidly in orange.
9
The device LED starts to flash in orange.
3. Take off the room control unit Display from the installation bottom (see page
5 fig. 3).
4. Pull out the insulating strip from the battery compartment, or insert batteries
(see page 5 fig. 4) If Batteries are inserted, shortly press the system key (D) in
order to activate the teach-in mode.
9
The teach-in mode is activated automatically for 3 minutes.
9
The device LED flashes in orange.
The LED will light up in green after a successful teach-in process. If the LED
lights up red, repeat the process.
5.1.2 Teaching-in to Alpha IP Access Point
For a control via the Alpha IP app, the teaching-in must of the RTD 61001-N1 must
be performed via the Access Point (HAP 21001). Teach-in the device as follows:
Ö
The Alpha IP Access Point has been set up via the Alpha IP App (see instructions
HAP 21001).
1. Open the Alpha IP app on the smart phone.
2. Select the menu item
Teach-in device .
3. Release the room control unit Display from the installation bottom (see page 5
fig. 3).
4. Pull out the insulating strip from the battery compartment, or insert batteries
(see page 5 fig. 4). If Batteries are inserted, shortly press the system key (D) in