DEU
ENG
FRA NDL ITA ESP DAN/NOR
FIN
SWE POL RUS
24
Commissioning
Alpha IP WTH 61001
is possible on different surfaces as e. g. masonry, furniture, tiles, or glass.
Ö
The commissioning is finished and the device is readily assembled.
1. Select a suitable installation position.
In case of an installation with adhesive strips the installation surface
must be even, smooth, undamaged, clean, and free from grease and
solvents.
2. Remove the protective foil from one side of the adhesive strip.
3. Stick the adhesive tape on the back side of the mounting plate in the
recesses provided for this purpose (see S in fig. (see fig. left).
4. Remove the protective foil from the other side of the adhesive strip.
5. Align the device horizontally at the desired position and press it on
the surface.
5.2.2 Installation with screws
Ö
Select a suitable installation position.
1. Ensure that no lines are laid at this position.
2. Remove the mounting plate from the device.
3. Position the mounting plate on the installation place. The arrow on
the front of the mounting plate must show upwards.
4. Align the mounting plate horizontally.
5. Mark two diagonally opposite bores using the mounting plate as a
template (see P in fig. left).
6. For stone walls, drill the marked holes with a 5 mm masonry drill.
If wooden walls are present, the screws can be directly screwed into
the wood. Pre-drilling with a 1.5 mm wood drill facilitates the screw
installation.
7. Insert the dowels into the bores.
8. Install the mounting plate with the supplied screws.
9. Install the interchangeable frame onto the mounting plate.
10. Position the device onto the mounting plate and latch it into the clips.
Q
P
Q
P