15
We reserve the right to modify technical specifications without prior notice.
83050700aUK – Translation of the operating manual
© Alpha-InnoTec GmbH
Feed the load and control cables as well as the
cables for sensors into the inside of the unit through
the openings provided at the rear of the unit…
For positioning of the rubber grommets for
feeding through the cables, see “dimensioned
drawing” for the respective model.
lay load and control leads in the cable duct inside
the unit all the way to the switchbox.
Install electrical connections according to the ter-
minal diagram and the circuit diagrams.
“Terminal diagrams” and “circuit diagrams” for
the respective model.
Important
Install electric connections only according to the
terminal diagram and the circuit diagrams that
apply to your model.
Important
Ensure clockwise rotary field of the load power
supply (compressor).
operation with the incorrect rotary direction of
the compressor can cause serious, irreparable
damage to the compressor.
Important
Ensure the power supply of the heat pump is fit-
ted with a 3-pole miniature circuit-breaker with
at least 3mm contact gap.
note the level of the tripping current.
“Technical data / Scope of delivery” overview,
“Electrics” section.
E
D
C
B
www.alpha-innotec.de
D - 95359 Kasendorf
Industriestraße 3
Alpha-InnoTec GmbH
1
1
Ers. d.
Ers. f.
Benennung
Durchflusssensor VFS5-100
603772
-
Zust.
Änderungstext
Datum
9.2.2009
HS
Von
Blatt
von
Werkstoff
Gewicht
-
Maßstab
1:2
Det. Maßstab
Datum
Name
Erstellt
Gepr.
Norm.
9.2.2009
Stenglein
toleranz
Allgemein-
DIN ISO 2768 -c
Oberflächen
ArtikelNr.
---
1
2
3
4
Schutzvermerk nach DIN 34 beachten
Blattformat: A4 hoch
Important
The sensor cable for heat quantity recording
may not be shortened!
note.
The control panel of the heating and heat pump
controller can be connected to a computer or
network using a suitable network cable, enabling
the heating and heat pump controller to be con-
trolled remotely from there.
If this is required, install a shielded network cable
(category 6, with RJ-45 connector) through the
unit when installing the connections and run it
through the front panel of the unit, parallel to
the existing control cable of the heating and heat
pump controller.
After completing all electrical installation work,
close the switchbox inside the unit…
Screw on the front panel of the unit, if no further
installation work inside the unit is to be carried out
immediately.
