11
Subject to change without notice | 83061500aUK – Translation into English of the original German operating manual | ait-deutschland GmbH
Undo the quick-release screws. Turn through 90° to
the left…
On both sides, pull the lower facing panel upwards and
outwards at an angle, lift out and put in a safe place...
LIFTING THE UNIT WITH TUBE HANDLES
REAR:
ATTENTION
Make sure that the tube handles do not damage
cable harnesses and components in the unit.
Lift the unit with the inserted tube handles, with at least
four people (one for each tube handle) and place on the
base. Make sure that the unit's baseframe is in full contact
with the surface of the ground.
Example: If the level difference between two unequal sound
sources is 5 dB, the level increase is an additional 1.2 dB.
INSTALLATION
Place the unit on a load-bearing, firm and horizontal
foundation. Make sure that the foundation is designed
for the weight of the heat pump. Materials that fulfil this
requirement can be used for the foundation (concrete,
paving slabs, etc.). The surface in the air outlet area of the
heat pump must be permeable to water.
ATTENTION
In the air outlet area the air temperature is approx.
5 K below the ambient temperature. Under certain
climatic conditions an ice layer can therefore form
in the air outlet area.
Install the heat pump so that the air is not blown
out in the area of footpaths.
NOTE.
Always refer to and follow the installation plan for
the respective model. Note the size and minimum
clearances.
Installation plan for the respective model.
PREPARING FOR INSTALLATION
Remove lower facing panels on the switch box side and
the water connection side of the unit…
1 Quick-release screws
2 Lower facing panel
