Page 2
Screw the tripod onto the bottom of the grey Alpha Match.
Screw the center support pole onto the top of the grey Alpha Match box.
Install the rubber grommet over the pole.
Locate the Clip with two openings:
Slide the clip with two openings onto the top of the
support pole.
Locate the
large Coaxial feed Loop:
Center and insert the large Coaxial feed Loop
snuggly into the top ‘slot’ of the Clip with the two openings.
Locate the
small Coaxial feed Loop:
Insert the small Coaxial feed Loop snuggly into the
bottom ‘slot’ of the Clip with the two openings.
Attach the PL259 connectors on the outer Coaxial loop to the grey box:
Attach the PL‐
259 connectors on the larger Coaxial Loop Element to the SO‐239 connectors on the grey
Alpha Match box.
Attach your coax:
Connect your PL259 to the T‐Connector on the small inner loop, and
then run your coax to your equipment. (NOTE – There is an extra T‐Connector included).
Tuning:
Start with
MINIMUM
power & select your frequency, then turn the black knob
on the grey Alpha Match till your rigs meter peaks with the loudest audible noise floor.
Second, watch your SWR meter to dip follow the next step to ‘Fine Tune’ if you so desire.
Fine Tune:
Slide the Inner loop up or down the center support pole while monitoring for
the lowest SWR on an inline SWR meter, your rigs SWR meter, or an antenna analyzer, as
you change the distance between the loops.
BEFORE
increasing your power to 100W, please ensure your SWR is optimally tuned.
Optional 40‐80M
Booster Cable
The Booster cable
enables 20W PEP SSB on
40/60/80M & installs in
Series
with the 10‐40M
outer loop, and clips into
the bottom opening of
the clip with 2 openings.
Содержание 100W Alpha Loop
Страница 3: ...Page 3...
