TIMER SETTING :
- Press Temps button to program the appliance to 1h. Timer indicator lights on.
- Press Temps button again to set timer until 12h (1 p1h).
WARM STEAM FLOW :
This function allows a better mist spray of warm droplets because there are more droplets into the
warm air than into cool air. The evaporation is higher and you have a best distribution of droplets.
It’s better to use in winter, because in summer ambient temperature will go up.
- Press Chaud button for a warm steam flow. Light indicator lights on.
- Press again Chaud button to stop warm steam flow, and to start cold steam flow. Light indicator goes
out.
MOISTURE RATE SETTING :
- Press HR % button to choose moisture rate. Press this button to settle the rate from 40% to 80%
( level of 5%). Screen flashes, then shows the ambient moisture rate.
- If ambient moisture level is up to the moisture level chosen, the appliance stops working
automatically.
AUTOMATIC CUT-OFF :
- This appliance is equipped with a warning bip and an automatic cut-off in case of waterless.
C L E A N I N G
C L E A N I N G
- Transducer : Take out the water tank from the base, empty the base and drop 10 ml of descaling
detergent on the transducer.
Wait about 2 to 5 minutes then wash with a brush and rinse plentifully with clear water.
- Water tank : file it half and add soft detergent. Screw the tank cap and shake it up and down several
times, and then use water to rinse.
- Water flume : clean it with a damp cloth and detergent, then rinse with water.
- Descaling cartridge (it’s useful to avoid the vaporisation of calcareous dust dissolved into the water) :
take it out and soak it into salt liquid ( one big spoon of salt in a glass of water) for about 60 minutes.
Rinse with clear water and replace in the product.
10
notice_hu50:notice_hu60.1_et 13/05/08 10:13 Page 10
