ALPATEC AC 9 FITP, Руководство пользователя

Страница: 18 / 24

18
FAN ONLY MODE.
It is no use adjusting temperature.
HEATING MODE.
There is an automatic regulation with a safety sensor.
When the sensor temperature is lower than 30°C, high speed is selected. When it is higher than 45°C,
low speed is selected. If it is between the two values, the speed can be selected manually.
AUTOMATIC MODE.
Your unit will choose the mode to be run according to the room temperature:
If T
≤ 20°C, heating mode.
If T > 24°C, cooling mode.
Si 20°C < T
≤
24°C, fan only mode.
STOP:
Press M/A (P).
A sound can be heard and the unit stops running.
TIMER:
To turn on the unit automatically, press TEMPS (M) when the unit is plugged but not running.
Set remaining time before starting using + / - (J). Each pressure adds or removes half an hour, from 0.5 to
12h.
Remaining time before starting is displayed on VFD screen and adjusted every half hour.
Press TEMPS to cancel the timer.
To turn off the unit automatically, press TEMPS (M) when the unit is running.
Set remaining time before stopping using + / - (J). Each pressure adds or removes half an hour, from 0.5
to 12h.
Remaining time before stopping is displayed on VFD screen and adjusted every half hour.
Press TEMPS to cancel the timer.
ADJUSTMENT OF THE WIND DIRECTION.
The unit has an automatic oscillation in both directions.
Press OSC (N) and OSC (O) to start or stop oscillations.
Corresponding indicator switch on or of on VFD screen.
notice_AC9FITP-reso 15/01/06 17:21 Page 18