1
.
Power
Key
·
Use this button to turn the dehumidifier on and off.
·
Press once to turn machine on. You will hear two beeps and the light will
illuminate green (solid or flashing depending on mode).
·
Press the power button a second time and you will hear one beep as the machine shuts
down. Note that there is a 1 minute fan delay.
2
.
Arrow
Buttons
·
Use
the
up
and
down
arrow
buttons
to
set
the
desired
humidity
setpoint
on
the
display
screen
.
·
The setpoint can be any number between 36%-90%. When the indoor humidity is higher
than the setpoint, the unit will operate.
• Keep in mind that the displayed humidity levels are approximate ( +/-5%)
3
.
Continuous
Mode
·
To set the unit to run continuously regardless of humidity, simply use the down
arrow key to set the humidity below 36%.
4
Key Functions
·
The continuous light will illuminate green and the display will show “CO”.
·
To switch back to normal humidistat operation, use the arrow keys to
move the setpoint above 36%.
4. Manual Drain Button
·
If you need to store or move your dehumidifier, press the “Drain” button to remove water
from the integral pump’s reservoir.
5. Pump Trouble Warning
·
If the pump reservoir level gets too high, the water sensor will activate to prevent
overflow.
·
When this occurs, the compressor will stop automatically, and the display will show “E4”.
After a 1 minute delay, the fan motor will turn off and the dehumidifier will not operate until
the problem has been resolved.
·
Check to verify that the pump is functioning, then unplug the unit for two minutes to reset
the error code.
