ALORAIR Sentinel HDi120, Инструкция по установке и эксплуатации

Страница: 5 / 15

Installation
1. Place dehumidifier on a level surface.
2. Set up the drain line
• Remove the compression nut and slide it over the end of the hose to be attached to unit.
• Slide the side of hose with compression nut over the insert on the compression fitting
completely.
• Tighten compression nut.
3. Plug dehumidifier into grounded 15 amp circuit.
• Do not place unit directly on vapor barrier. For example, use blocks or pavers to create a
level surface.
• If unit has been turned or flipped so that the compressor did not remain upright, place the
unit on a level surface and wait a minimum of 2 hours before proceeding.
Key Functions
1
.
Power Key
illuminate green (solid or flashing depending on mode).
•
Press the power button a second time and you will hear one beep as the machine shuts
down. Note that there is a 1 minute fan delay.
2
.
Arrow Buttons
·
Use the up and down arrow buttons to set the desired humidity setpoint on the display
screen .
·
The setpoint can be any number between 36%-90%. When the indoor humidity is higher
than the setpoint, the unit will operate.
• Keep in mind that the displayed humidity levels are approximate ( +/-5%)
3
.
Continuous Mode
•
To set the unit to run continuously regardless of humidity, simply use the down
arrow key to set the humidity below 36%.
4