9. Install Screw Covers (optional)
Use a hammer to tap the provided screw covers into the pre-
drilled holes in the Wall Panels to give the sauna a seamless
finish.
10. Connect to Power Source
Your sauna plugs directly into a 110V, 20 Amp dedicated
outlet.
Operating Instructions
Follow these instructions for operation of your Radiant Infrared Sauna.
CONTROL PANEL
All functions of the
Radiant Sauna will be
accessed through the
control panel. There is a
control panel on the
interior and exterior of
the sauna, and both are
identical and perform the
same functions as well as
simultaneously display
the same information. You can operate the sauna
from either the interior or exterior control panels.
POWERING UP THE HEATERS
Press the POWER button and hold until the control
panel beeps, then release the button. The control
panel will now light up and the heaters are on.
Press the POWER button a second time for 5
seconds until the control panel beeps, and when you
release the button the control panel lights will turn
off . The heaters are now off. When the control
panel is lit up, the TEMP and TIME displays will
show the temperature and time settings last used in
the sauna.
SETTING THE TEMPERATURE
When heaters are on you can adjust the sauna
temperature. The temperature can be adjusted in
increments of 5F and can be set as high as 165F.
Press the TEMP+ or TEMP- to adjust the heater
temperature. The temperature will appear in the
display. After 5 seconds the display will reflect the
current sauna temperature. If the ambient
temperature in the outside room is under 65F, the
temperature display will read “LO” until the sauna
gets warm. It will display the actual temperature
once the sauna gets up to about 75F.
SETTING THE TIME
You can adjust the operating time of the heaters
from 5-60 minutes. The heaters will automatically
turn off after 60 minutes, at which time you can
turn them back on if you choose. Press the TIME+
or TIME- to change the time setting in increments
of 5 minutes. The system will beep 3 times when 5
minutes remain for the heater cycle.
