Step 4. Position Wall Sections C, D, & E
Position wall section C into the groove of the back rail. Attach it to wall section B by way of the tongue and groove fit (Images 19 & 20). Secure it
by tapping it into place with a rubber mallet. Repeat this step for wall section D, again tapping it into place with a rubber mallet (Images 21 & 22).
Position wall section E into the groove to the right side rail and push flush against the back rail (Image 23). Being sure panels D & E are flush with
each other, fasten them together using the 2” screws (Images 24 & 25).
Step 5. Bench and LED Backrest Installation
Note: You may choose to install all the benches and backrests after the sauna is completed, but you may find it easier to install with the extra
space and light afforded at this step.
Place the wider upper bench on the pre-installed upper bench supports and push flush against he back wall, being sure the side of the bench
with the screws showing is oriented towards the back (Images 26 & 27). Secure the bench to the back and side panels using 2.5” bench screws
and the pre-drilled holes in the bench frame supports (Images 28 & 29).
Repeat this process for the lower long bench, aligning the face of the bench frame flush with the front edge of the pre-installed lower bench
supports. Fasten the lower bench to the side walls using 2.5” screws (Images 30 – 33).
Image 19
Image 20 Image 21
Image 26
Image 27 Image 28
Image 29
Image 30
Image 31
Image 32 Image 33
Image 22
Image 23
Image 24
Image 25
Orient to
back
BRIDGEPORT | BRAXTON SAUNA INSTALLATION MANUAL
page 3
