OPERATING INSTRUCTIONS
1. Attach the clear discharge tube (5 metres supplied) to the outlet by
removing the nut and sliding it back over the tubing. Then push nut and
tube over the fitting and tighten,
2.
Tubing should then be piped to a drain or container.
3. Plug dehumidifier into the wall and turn on at switch.
If the unit has not been used recently it will start operating within a few
seconds. Screen will show ambient (current) room temperature and
humidity.
4.
Set desired humidity using the plus and minus buttons. Humidity
percentage will flash for a few seconds then set. The panel will then
revert to current room humidity.
5. If
the unit has recently been used it will not start up until the Power button
is pressed. There is then a 3 minute delay before fan starts. This is to
protect the compressor.
The desired humidity
must be less than the current room humidity
,
otherwise the dehumidifier will register as reaching optimum and not
operate.
6. When the dehumidifier is operating, the orange dehumidification light will
be showing, fan symbol spinning and the water droplet symbol pulsing.
(Dynamic display)
7.
If required, you can set a timer to turn the dehumidifier off after a set
number of hours. This can be done while the unit is operating. Press the
Function button once and then the plus or minus button to set the run
time in hours. The display will show TIMER OFF and number of hours
remaining until unit will automatically turn off.
8.
There is a small holding tank in the dehumidifier – once this is full the
pump sensors will register it as being full and discharge the water through
the clear tubing.
9.
To turn the unit off, press Power button. There is a time delay for 60
seconds, during which time fan will run to allow machine to cool down.
10. Once the fan has stopped you can then turn it off at the wall.
11. When machine is not being used, cover with supplied dust cover to
prevent dust and overspray entering machine.
