Alma FLEXICOMPT AUTONOME+, Руководство по эксплуатации, Страница: 4 / 4

GU 7033 EN I
FORM DOC 124 A
LIST OF ALARMS
DISPLAY MEANING ACTION
FLoV_ Flow setting fault Check the parameters
FrEQ_ Frequency fault Check the parameters
COEFF_ Difference between two coefficients is greater than 0,5% Check the coefficients setup
MEtEr Problem of metering with the meter Check the setup
LoW_FLo
HiGH_FL
Flow rate less than the setting minimal flow rate
Flow rate greater than the setting maximal flowrate
Check the hydraulic configuration and the flowing
Check the setup
dAtE Loss of date and time Set date and time in metrological mode
GAS GDh is wet but GDl is dry Check the hydraulic configuration / Check the detector status
SEnSor1
SEnSor2 High gas detector fault (GDh)
Low gas detector fault (GDl) Use the maintenance menu to check the status of the detector
CoiL Loss of pulse transmitter signal Check the connection with the pulse transmitter
tEMPErA Temperature less than -20°C or greater than 50°C Check the temperature sensor (measure and calibration)
diSPLAY
doG
LCD display fault
Fault with card
If steady alarm, substitution of the UNI
If steady alarm, substitution of the UNI
ProGrAM
rAM
Error on the checksum of the metrological data
Saved memory fault
If steady alarm, substitution of the UNI
If steady alarm, substitution of the UNI
MEMoriS Bad writting into the memory If steady alarm, substitution of the UNI
FuLL
If a measurement result, not older than 3 months, is about to be
erased
If steady alarm, substitution of the UNI
oVErFLo Volume greater than 4 194 304 liters Reset the device
MEtro_ Configuration loss If steady alarm, substitution of the UNI
bAttErY Low battery Substitution of the batteries
totAL_ Totaliser fault If steady alarm, substitution of the UNI
dEF_MEM Loss of backup data concerning the last measurement If steady alarm, substitution of the UNI
Use the maintenance menu to check the status of the detector
R
E
P
A
R
A
T
O
R
U
S
E
R
LF_HiGH Flow greater than 20m
3
/h while GDh dry Check the setup
drY MEt
When using a pump. The volume of gas is greater than the
minimum measured quantity
Stop metering
dEF_CoM Communication fault with IRDA link Check the IRDA link
rECEPt Check the compatibility
Problem of communication protocol between the calculator-
indicator UNI and the CTD+ key