AlluGuard AG55, Руководство по эксплуатации, техническому обслуживанию, обслуживанию и установке

Страница: 19 / 28

18 19
9.2 Connecting the Receiver to the Mains Power Supply
9.2.1 Fully unfold the receiver aerial so that it is pointing downwards.
9.2.2 Screw the bulb supplied into the receiver. (Before connecting to mains power supply)
9.2.3 Replace and screw in the receiver cover.
9.2.4 Refit the integrated light cover.
9.2.5 Connect the receiver to the mains power supply.
All the indicator lights come on and then go out.
If indicator light 1 comes on permanently, fall protection is not connected or incorrectly connected to the
receiver.
If indicator light 2 comes on permanently, the safety edge has not been detected by the receiver (radio safety
edge transmitter not yet memorised or the wired safety edge is still not connected).
9.3 Checking the Direction of Rotation of the Motor and Adjustment of the Motor End Limits
9.3.1 Press simultaneously on the ^ and v buttons until the motors up and down movement occurs to enter
motor adjustment mode.
• Indicator light 1 flashes slowly.
9.3.2 Press button ^ or v to check the motor’s direction of rotation.
If the motor’s direction of rotation is correct, move on to step
[3]
of the motor end limit setting procedure.
If the direction of rotation is incorrect, press button
(stop)
until the motors up and down movement occurs,
check the motor’s direction of rotation again and move on to step
[3]
of the motor end limit
setting procedure.
9.3.3 If the motor end limits are already set, move on to step
[8]
to exit motor adjustment mode.
• If the motor end limits are not set, check that the motor is released: the two push-buttons should
be pressed.
Note:
The motor end limits can also be set with a setting tool (ref. 9015971).
In this case, set the motor end limits with the cable then move on to step
[8]
to exit motor adjustment mode.
9.3.4 Press ^ button to position the garage door in the upper position.
• Adjust the upper position with buttons ^ and v.
9.3.5 Press the motor’s upper end limit push-button.
9.3.6 Press v button to position the
garage door in the lower position.
• Adjust the low position with
buttons ^ and v.
9.3.7 Press the motor’s low end limit
push-button.
9.3.8 Press simultaneously on the ^
and v buttons or press the (prog)
button until the motor’s up and down
movement occurs to enter motor
adjustment mode.
• Indicator light 1 goes out.