Step 1
- Complete Assembly while inverted on a clean, dry surface.
Step 2
- On one side, slide the Top Crossbeams into the respective spots on the Short Legs and secure with 4
A
screws. Next, slide the Stretcher Bar onto respective barstock and secure with 4
A
screws. Make sure to
support the opposite end of the Pitchfork during installation.
Step 3
- Repeat Step 2 on the other side, securing with 8
A
screws.
Step 1
- Place worksurface topside down on a clean, dry surface. Place assembled base on top.
Step 2
- Align pilot holes on the underside of the worksurface. Use 24
B
screws to attach base to worksurface through
attachment plate. Stand unit upright and adjust levelers.
*** All pilot holes must have a fastener installed***
Support pitchfork
during installation
Installation Packet
Create
Park
3430408700
Page 3 of 9
Illustration 1c: 96” Racetrack Conference Table Assembly
350-1675
A x 16
Illustration 1d: Worksurface Attachment
B x 24
2
3
