Alloy J-Style, Руководство по сборке

Страница: 18 / 26

1 December 2017 14 P+JAssem Version 1.1
strings as straight edges to make sure that the neck is straight relative to the bridge. (Figure 29).
• Now look at the distance from each of the strings to the edge of the neck and measure with a ruler slid
under the strings. Compare these two distances. (Figure 30)
• The distances should be very close to the same. If adjustment is needed, lightly tap on the tuner head
of the guitar with you hand to adjust the neck alignment. If the neck won’t move with a gentle nudge,
you may need to loosen the neck mount screws slightly and try again. If you can’t get good alignment
after loosening the screws a bit, please see below.
• Once the alignment is set, gently turn the guitar over and tighten the screws in the neck plate. Tighten
these by hand! A power screwdriver is likely to over tighten and/or damage the screws!
• Turn the guitar back and check the alignment again.
4.11. Neck Alignment
At this point the neck and the bridge are set.
4.12. Installing the Strap Buttons
This is a very easy step in the process, but definitely in the High Scratch Risk Zone!. Go slow, and be
patient.
• Locate the two button holes on the body. One on the end, and one on the top. Ensure the holes are
clear of paint and sealer. Use 1/16” bit to manually clear if needed.
• Place painters tape around both holes to protect around them. (Figure 31, Figure 32)
Figure 29 Line to check alignment
(An S-style guitar is shown; the process is
identical for J- and P-style basses)
Figure 30 String to edge distance matches
Troubleshooting!
• If the neck will not align, gently remove the screws and lift the neck out if the neck pocket.
• Inspect both the neck and body for excess paint or sealer that may be affecting the fit.
• Remove any unwanted material with #320 or #400 grit sand paper.
• If you are still having alignment problems, please contact us!