Page 6
ALL 3000RFMk2 INTERNET REMOTE CONTROL
The ALL3000RFMk2 does not have a local temperature sensor, but can access all
types of sensors (temperature, humidity, air pressure, voltage, light level...) that are
connected to an ALL3000 unit in the network. You just have to enter the ALL3000´s
IP address and UDP port number here, to make the ALL3000RFMk2 listen to the data
packets that are sent by the ALL3000 to it.
Note: You also have to enter the 3000RFMK2´s IP adress and matching port number
in the ALL3000´s “UDP Server Push” configuration.
Default: 192.168.20.83
Number of UDP port to listen to.
Default: 12345
is placed between the device to be switched and the wall power outlet. It can switch
up to 3.5 KW (15 Amps at 230V).
The two dials on the back side must match the selection in the ALL3000RFMk2
Remote Control.
Note that the ALL3000RFMk2 begins to count nubers from "0", while some switches
are laelled 1...16 instead of 0...15 - on such switches, please keep in mind that
counting always begins at zero and correct the value.
ALL3000 UDP config
UDP Port Number
The Radio Controlled Switch ALL3110
