26
CAUTION: PREVENT POSSIBLE INJURY FROM UNEXPECTED MACHINE
MOVEMENT. NEVER RELY ON NEUTRAL POSITION OF FOOT PEDAL ALONE TO
KEEP THE MACHINE FROM ROLLING. THE MACHINE CAN UNEXPECTEDLY ROLL
OR MOVE UNDER POWER RESULTING IN SERIOUS INJURY OR DEATH.
ALWAYS ENGAGE PARK BRAKE TO HOLD MACHINE STATIONARY!
STOPPING THE ENGINE-Diesel Engine
Before leaving the operator’s station
:
1. Park the machine on a level surface and lower loader bucket, backhoe bucket and any
other accessories to the ground.
2. Engage park brake.
3. Place the throttle in the
“slow”
position.
Allow the engine to run at least 15 seconds
before stopping the engine.
4. Turn the key switch to the
“off”
position.
5. Move hydraulic control levers to release hydraulic pressure from the system.
CAUTION: PREVENT POSSIBLE INJURY FROM UNEXPECTED MACHINE
MOVEMENT. NEVER RELY ON NEUTRAL POSITION OF FOOT PEDAL ALONE
TO KEEP THE MACHINE FROM ROLLING. THE MACHINE CAN UNEXPECTEDLY
ROLL OR MOVE UNDER POWER RESULTING IN SERIOUS INJURY OR DEATH.
ALWAYS ENGAGE PARK BRAKE TO HOLD MACHINE STATIONARY!
ENGINE ANGLE OF OPERATION:
The engines
can be operated at angles up to 25 degrees. Check oil level to assure crank-
case oil level is at the full mark.
NOTE:
Do not operate this engine continuously at angles exceeding 25 degrees in any
direction.
Serious engine damage can occur from insufficient oil supply
.
COOLING:
NOTE:
If debris builds up on the grass screen or other cooling air intake areas, stop the
engine immediately and clean. Running this engine with blocked or dirty air intake and
cooling areas can cause extensive damage due to overheating.
ENGINE SPEED:
NOTE:
Do not tamper with the governor setting to increase the maximum engine speed.
Over speed is hazardous and will void engine warranty. The maximum allowable high
idle speed for the
Allmand TLB
is 3400 RPM (gas engine) and 3000 RPM (diesel
engine) with no load.
BATTERY:
The
Allmand TLB
is shipped with a 12 volt, group 24 battery with a 675 CCA rating.
Check battery electrolyte level regularly and fill as needed.
Replace with the same group size and amp rating when replacement is needed.
NOTE:
The
TLB
electrical system is a 12-volt negative (-) ground.
CAUTION:
An explosive gas is produced while batteries are in use or being charged.
Keep flames or sparks away from the battery area. Make sure batteries are charged in a well-
ventilated area. Always wear eye protection when servicing or handling batteries.
!
Not
for
Reproduction
Содержание TLB 220
