Configuration of the camera
STINGRAY Technical Manual
V4.4.2
340
Software feature control (disable LEDs)
The software feature control register allows to enable/disable some features
of the camera (e.g. disable LEDs). The settings are stored permanently within
the camera and do not depend on any user set.
Disable LEDs
•
To disable LEDs set bit [17] to 1.
•
To disable LEDs in SmartView:
Adv3
tab, activate
Disable LED functionality
check box.
The camera does not show any more the status indicators during normal oper-
ation:
Examples:
•
Power on is not shown
•
Isochronous traffic is not shown
•
Asynchronous traffic is not shown
Register
Name
Field
Bit
Description
0xF1000640 SWFEATURE_CTRL Presence_Inq
[0]
Indicates presence of this feature
(read only)
BlankLED_Inq
[1]
Indicates presence of
Disable
LEDs
feature.
---
[2..15]
Reserved
---
[16]
Reserved
BlankLED
[17]
0: Behavior as described in Chap-
ter
1: Disable LEDs. (Only error codes
are shown.)
---
[18..31] Reserved
Table 166: Advanced register:
Software feature control
(disable LEDs)
Note
During the startup of the camera and if an error condition
is present, the LEDs behave as described in Chapter