Camera interfaces
STINGRAY Technical Manual
V4.4.2
98
Status LEDs
Each of the two LEDs is tricolor, showing green, red or orange.
RED
means: red LED permanent on
RED blinking
means: red LED blinks fast
+RED pulsing
means: red LED is switched on for a short time. If the red LED
is already on, the LED will be switched off. The state of the other color of the
same LED could be on or off.
GREEN
means: green LED permanent on
GREEN blinking
means: green LED blinks fast
+GREEN pulsing
means: green LED is switched on for a short time. If the
green LED is already on, the LED will be switched off. The state of the other
color of the same LED could be on or off.
+GREEN pulsing (inverted)
means: green LED is switched off for a short time.
Figure 47: Position of status LEDs
Note
Both LEDs can be switched off by:
•
Setting bit [17] to 1, see
Software feature control (disable LEDs)
•
Activating
Disable LED functionality
check box in
SmartView (
Adv3
tab).
Error conditions will be shown although LEDs are switched
off.
Status LEDs
LED2
LED1