Allied 5500, Техническое руководство, Страница: 50 / 68

7. Tighten the square head screws and
nuts of the Hose Coupling Clamp. Refer
to Figure 9-31.
a. Use a 3/4-inch open-end wrench to
hold the hex head nuts.
b. Use a 5/8-inch open-end wrench to
back the square head screws almost
out of the nuts.
9.9 Assemble Body/Anvil, Striker and Tail
Assembly
~
WARNING
The Body/Anvil and Striker are
heavy. Bodily injury could result
from improper handling of heavy
components.
NOTE
The Body/Anvil and Striker are not
customer
serviceable. If these
components are worn or damaged,
replace them with new components.
1. Refer to Figure 9-32, and gather the fol-
lowing components for final assembly:
•
The Body/Anvil (1).
• The Striker (2)
•
The Tail Assembly
2. Remove packing from new components
and protective wrappings from stored
components.
3. Place the Body/Anvil (1) on the work
surface. Block it so the open end is easily
accessible and the Body/Anvil will not
accidentally roll off the work surface.
Refer to Figure 9-33.
4. Coat the Striker (2) with hydraulic fluid
before installing it into the Body/Anvil
(1).
5. Refer to Figure 9-34 and slide the
Striker (2) into the Body/Anvil (1). The
back end of the Striker should be about
6 in. to 8 in. in (past the threads of the
Body/Anvil).
A
LLIED Model 5500 Hole-Hog
40 08/25/00
Body/Anvil.
Striker
Tail Assembly
Figure 9-32. Components for Final Assembly
Tighten Screws and Nuts on both sides
of the Hose Coupling Clamp
Figure 9-31. Secure Whip Hose to Coupling.
Secure Body/Anvil to Lifting Device
with Lifting Strap or Chain
Block Body/Anvil side to side to
prevent rolling during assembly.
Block end of Body/Anvilfor clear access
to threaded opening.
Figure 9-33. Block Body/Anvil for Assembly