Prosilica GS Technical Manual V2.2.2
37
Camera interfaces
*Cameras with SN: 02-XXXXX-0XXXX, R1 necessary for input greater than 5 V,
see table above. Cameras with SN: 02-XXXXX-1XXXX, no R1 is necessary, 5 to
24 V.
Isolated output is connected to the open collector of Fairchild MOCD207. The
corresponding transistor emitter is connected to isolated ground. See the
Fairchild MOCD207 data sheet for more detailed information.
Camera I/O non-isolated user circuit example
Caution
Input: Incoming trigger must be able to source 10 mA.
Output: User power, with pull-up resistor R2 is required.
Figure 17: Prosilica GS non-isolated trigger user circuit
Caution
Input: Incoming trigger must be able to source 10 µA, at 3.3 V.
Input trigger voltage greater than 5.5 V will damage the
camera.
Output: The maximum sync output current is 24 mA, at 3.3 V.
CABLE SIDE
IN 2 (3.3 V DRIVER)
CAMERA GND
3M 10114-3000PE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
OUT 2 (3.3 V RECEIVER)
CAMERA POWER
