Allied Telesis IE048-480, Руководство по установке

Страница: 58 / 72

Chapter 3: Installing the Power Supply
58
Wiring the Power Alert DC_OK Connector
For background information, refer to “Power Alert DC_OK Connectors” on
page 27. This procedure requires the following:

Two DC_OK connector wires. Refer to Table 10 on page 46 for the
specifications.

Cross-head screwdriver (not provided).

Wire insulator stripper (not provided).

Alert device (not provided).
To wire the Power Alert DC_OK connector, perform the following
procedure:
1. Prepare adequate lengths of cables by stripping 8mm of insulation
from the ends.
2. Loosen the two DC_OK connector screws on the front panel and insert
the wires into the connectors on the top panel. Refer to Figure 16.
Figure 16. Wiring the DC_OK Connector
3. Tighten the screws to secure the wires.
4. Visually inspect the wires for exposed wires and loose strands. Refer
to Figure 10 on page 47.
5. Connect the wires to the alert device.