Allied Telesis AT-MMC1000/SP, Руководство по установке

Страница: 38 / 50

Chapter 2: Installation
38
2. Plug the power adapter to a power outlet. Refer to “Power
Specifications” on page 44 for power requirements.
3. Verify that the PWR LED is lit green. If the PWR LED is off, refer to
“Troubleshooting” on page 39.
4. Verify that the SYS LED is lit green. If the SYS LED is off, refer to
“Troubleshooting” on page 39.
5. Remove the dust cover from the fiber-optic connector and connect the
cable to the fiber-optic port.
Connect the red TX connector on the fiber-optic cable to the
transmitter port on the SFP module and connect the other connector to
the receiver port on the end node. Then connect the black RX
connector on the fiber-optic cable to the receiver port on the SFP
module and connect the other connector to the transmitter port on the
end node.
6. Connect the twisted-pair cable to the twisted-pair port.
For speed/duplex interactions between the copper port and the copper
link partner, refer to Table 3 on page 32 for allowable speed/duplex
combinations.
7. Power on the end nodes.
The media converter is now ready for use.