Allied Telesis AT-FS705PD, Руководство по установке

Страница: 27 / 48

AT-FS705PD Fast Ethernet Switch Installation Guide
19
6. Power ON the switch.
There are two ways to power ON the switch; perform one of the following
steps:
❑
Using a wall power adapter: Plug one end of the power cord to the
24VDC power connector on the back of the switch and the other end of
the power cord to a power outlet.
❑
Using the POE port: Make sure that no power plug is inserted in the
24VDC power port. Then plug one end of the twisted pair cable to the
POE port on the back of the switch and the other end of the twisted
pair cable to an Ethernet port on a PSE device.
7. Verify that either the PWR POE or WALL LED is green. If the LED is
OFF, refer to “Troubleshooting” on page 21 for instructions.
8. Power ON the end-nodes connected to the switch.
9. Check the LINK/ACT LEDs for each port is green. If a LED is OFF, refer
to “Troubleshooting” on page 21 for instructions.
The switch is now ready for use.