Allied Telesis AT-FS7016, Руководство по установке

Страница: 29 / 48

AT-FS7016 and AT-FS7024 Installation Guide
19
Note
The switch performs a self-diagnostic test upon power up. This takes
about 20 seconds to complete.
6. Connect the twisted pair cables to a twisted pair ports on the switch and on
the end-nodes. When connecting a twisted pair cable to a port on the switch,
observe the following:
❑
An RJ-45 connector should fit snugly into the port on the switch. The
tab on the connector should lock in connector into place.
❑
Since the ports on the switch are auto MDI/MDI-X, you can use either
a straight-through or crossover twisted pair cable to connect any type
of network device to a port on the switch. Refer to “Auto MDI/MDI-X”
on page 6 for additional information.
❑
If you are creating a port trunk, do not connect the cable of the trunk
to the switch until you have configured the trunk using the
management software. Connecting the trunk cables to the switch
before you have configured the software will result in a data loop,
which can adversely affect network performance. For instructions on
how to configure a port trunk, refer to the
AT-S67 and AT-S68
Software Management User’s Guide .
7. Power ON the end-nodes connected to the switch.
8. Check that the LINK/ACT LED for each port on the switch is green. If a
LED is OFF, refer to “Troubleshooting” on page 21.
The switch is now ready for use. Refer to the AT-S67 and AT-S68 Software
Management User’s Guide to manage and configure your unit. This guide is
available at www.alliedtelesyn.com .
Warranty Registration
When you finish installing the product, you should register you product by
completing the enclosed warranty card and sending it in.