Allied Telesis AT-FAN08, Руководство по установке

Страница: 57 / 214

AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
57
Switch ID Numbers
Each switch must be assigned an ID number. The range is 1 to 4. The
default is 1. The ID numbers are displayed on the ID LEDs on the front
panels of the units. You can assign the numbers yourself or let the master
switch assign the numbers automatically when you initially power on the
stack, as explained in Chapter 8, “Powering On and Verifying the Stack”
on page 167.
You use the ID numbers to identify the individual ports and switches when
you configure the devices with the commands in the management
software. For further information, refer to “Specifying Ports in the
Command Line Interface” on page 35.
The ID numbers are also used to identify the parameter settings that are
stored in the configuration file. When the stack is reset or power cycled,
the ID numbers identify the devices to which the parameter settings
belong.
Caution
You should not change the ID numbers of the switches after you
start to configure the parameter settings. Otherwise, the parameter
settings might be applied to the wrong devices when you reset or
power cycle the stack.

E79
The switches do not use the ID numbers to select the master switch. The
selection of the master switch is based on the priority numbers and MAC
addresses, as previously explained.