Allied Telesis AT-FAN08, Руководство по установке

Страница: 29 / 214

AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
29
The Network Management (NET MGMT) port has one Status LED,
described in Table 7.
Console (RS-232)
Port
You can use the Console Port to conduct local management sessions of
the switch. Local management sessions require a terminal or PC with a
terminal emulation program, and the management cable that comes with
the switch.
Local management sessions are not conducted over a network.
Consequently, the switch does not need an Internet Protocol (IP) address
for this type of management.
Because the switch does not come with a default IP address, your initial
management session must be a local management session. For
instructions on how to start a local management session, refer to “Starting
a Local Management Session” on page 145 or the Software Reference for
SwitchBlade x908 Gen2 Switch.
Switch ID LED
The Switch ID LED, shown in Figure 4 on page 27, displays the ID number
of the switch. The states of the LED when the switch is not operating in the
low power mode are shown in Figure 5 on page 30.
Table 7. NET MGMT Port LED
State Description
Solid Green The port has established a 1000 Mbps link
with a network device.
Flashing Green The port is transmitting or receiving data
at 1000 Mbps.
Solid Amber The port has established a 10 or 100
Mbps link.
Flashing Amber The port is transmitting or receiving data
at 10 or 100 Mbps.
Off The port has not established a link to a
network device.