Hardware Reference
23
C613-03059-00 REV F
7.
Save the current session by selecting Save from the File menu on the main
HyperTerminal window. This creates a connection icon with the name you
assigned in the HyperTerminal group.
To use the configuration, double-click the connection icon. When the
HyperTerminal window appears, press the Enter key several times; the
switch’s login prompt is then displayed.
Switch Startup
This section describes the log in and startup procedures for your AT-9800 Series
switch. Although the switch will perform basic switching operations without
being configured, you will need to go through these log in and startup
procedures if you wish to configure the switch and access its full layer 3
switching capabilities.
To log In
To log in you must first connect the switch to a terminal or PC. This can be
done using the RS-232 terminal port (ASYN0).
A terminal cable suitable for use
with ASYN0 is supplied with each switch.
Using the supplied terminal cable, or a cable you have made by following the
instructions in
“Cables” on page 14
, connect your terminal or PC to ASYN0.
Set the communication parameters on your terminal or terminal emulation
program to:
■
Baud rate: 9600
■
Data bits: 8
■
Parity: None
■
Stop bits: 1
■
Flow control: Hardware
See
“Using Windows Terminal and Windows Hyperterminal” on page 20
for
more information on configuring emulation software.
Ensure that any power switches are in the On position and that the switch is
receiving power.
After the switch has booted, the login prompt appears. If the login prompt
doesn’t appear, press [Enter] two or three times.
When the switch boots for the first time it automatically creates an account
with manager privileges. The account has the login name “manager” and the
password is “friend”.
At the login prompt, enter the login name and password.
Log in: manager
Password: friend
The command prompt appears and you can now configure the switch using
the command line interface.
