Allied Telesis AT-7101GHTm, Руководство по установке

Страница: 26 / 34

AT-7101GHTm PoE Injector Installation Guide
26
Installing the
Power Adapter
on a Wall
To install the AT-7101GHTm PoE Injector on a wall, perform the following
procedure:
1. Provide the following items:

Power Adapter

Two Brackets for the power adapter (included in the shipping box)

Cable tie (included)

One screw (M3x5mm) to attach the cable tie

C13/C15 Power cord (included)

Phillips-head screwdriver (not included)

Four screws to attach the brackets to the wall (not included)
2. Place the power adapter on a flat, secure surface, such as a desk or
table.
3. To attach the cable tie to the one of the bracket, align the cable tie to
the bracket as shown in Figure 11.
Note
The cable tie has two sides. One side has a few teeth at the pointy
edge and the other side has teeth from the edge to edge. For the
orientation in Figure 8, the side with a few teeth must be up and
visible.
Figure 11. Aligning the Cable Tie to the Bracket
4. Tighten the screw with a Phillips-head screwdriver to attach the cable
tie to the power adapter bracket. See Figure 12 on page 27.