Allied Telesis AT-2711FX, Инструкция по установке и эксплуатации

Страница: 60 / 180

Installing Windows 2000 Driver Software
60
5. From the Properties list, select Speed & Duplex .
6. From the Values list, select one of the following:
ˆ
100 Mb Full. Sets the speed at 100 Mbit/s and the mode to Full-
Duplex.
ˆ
100 Mb Half. Sets the speed at 100 Mbit/s and the mode to Half-
Duplex.
ˆ
10 Mb Full (not supported on the AT-2711FX Fast Ethernet
adapter) and 100 Mb Full settings force the network adapter to
connect to the network in Full-Duplex mode. The network adapter
may not function if the network is not configured to operate at the
same mode.
7. Click OK .
8. If prompted to restart your computer, click Yes .
Even though it is not necessary to reboot the system for new adapter
properties to take effect, rebooting is recommended to reinitialize all
registers.
9. Verify that the adapter port LEDs operate as described in “Physical
Description” on page 20.
Wake Up
Capabilities
The Wake Up Capabilities property enables the network adapter to wake
up from a low-power mode when it receives a network wake-up frame.
Two types of wake-up frames are possible: Magic Packet and Wake Up
Frame.
To change the Wake Up Capabilities property, perform the following
procedure:
1. Start either a Windows Server 2003 system or a Windows XP system
and log in.
You must have Administrator privileges to update the driver software.
2. On the desktop, right click My Computer .
The My Computer window opens.
3. Select Properties from the menu.
The System Properties dialog box opens, as shown in Figure 8 on
page 36.
4. Click the Advanced tab.
The Advanced tab is shown in Figure 13 on page 42.