Allied Telesis AT-2711FX, Инструкция по установке и эксплуатации

Страница: 52 / 180

Installing Windows 2000 Driver Software
52
Installing the Windows 2000 Driver Software
Note
The Allied Telesyn adapter must be physically installed in your
system before installing the driver software. See Chapter 2,
“Installing the Hardware” on page 21 for details.
When the Windows 2000 system first boots up after installing a new
hardware device, such as an Allied Telesyn adapter, the system
automatically detects the new hardware and prompts you to install the
driver software for that device.
If the system automatically loads an onboard Broadcom adapter driver.
You can use this driver, or the latest one supplied by Allied Telesyn.
A network device driver must be installed before you can use the Allied
Telesyn adapter with your Windows 2000 system.
Installing the
Adapter Software
When you update the adapter software on existing Allied Telesyn devices,
the Advanced Property settings may not be updated unless you remove
the existing Allied Telesyn device by following the instructions in
“Removing the Driver Software” on page 64. Then you must perform a
scan for hardware changes in the device manager and reinstall the Allied
Telesyn device with the current adapter software as described in
“Installing the Windows 2000 Driver Software” on page 52.
To install the adapter software for Windows 2000, perform the following
procedure.
Note
Before beginning this procedure, verify that the Windows 2000
system has been upgraded to the latest version with the latest
service pack applied.
1. Start your Windows 2000 system and log in.
Note
You must have Administrator privileges to install the driver software.
When you boot up the Windows 2000 system after installing the
adapter card, a series of windows opens.
2. In the Install Hardware Device Drivers window, click Search for a
suitable driver for my device (recommended) , then click Next .