Quick Install Guide
7
C613-04045-01 REV A
1.
Connect the PC to a router switch port.
The PC can be connected directly, or through your LAN.
To connect the PC directly to the router, use a straight-through Ethernet
cable to connect an Ethernet card on the PC to any one of the router’s
switch ports. Note the PC’s IP address and mask.
To connect via a LAN, use a straight-through Ethernet cable to connect the
router’s switch port(s) to the device(s) on the LAN. Select the LAN PC
from which you wish to configure the router. The PC should be in the same
subnet as the part of the LAN that contains the router (for example, the PC
could be connected to a hub or Layer 2 switch that is directly connected to
one of the router’s switch ports). Note the PC’s IP address and mask.
2.
Access the CLI on the router.
Follow the instructions in the previous Using the CLI to configure a router
section.
3.
Enable IP.
At the CLI, enter the command:
ENABLE IP
Hub or
switch
