ALLIANCE TR3000WN, Руководство пользователя

Страница: 23 / 25

Washer Symptom Possible Cause/Solution
Too Many Soap Suds • Laundry load may be oversudsing. Make sure you are us-
ing low-sudsing, high efficiency (HE) detergent.
• Make sure you are using the amount of detergent recom-
mended on the detergent’s label. If using non-HE deter-
gent, use only 1/2 of the detergent manufacturer's recom-
mended amount.
• Laundry load may be overloaded. Make sure you are using
proper load sizes.
Status Lights Flashing Status lights may flash or remain on continuously to indicate
an error condition. The number of flashes listed below is fol-
lowed by a pause. Then the flash sequence will repeat.
WASH, RINSE STATUS lights flash 2 times
Fill Error
• This code will appear if the washer has not reached the fill
level after 30 minutes during a wash or rinse fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
WASH, RINSE STATUS lights on continuously
Drain Error
• This code indicates that water is still in the washer at the
end of the cycle.
• Check the drain hose and drain receptacle to make sure
they are installed properly and not blocked.
• Unplug the machine for 15 seconds to clear this code.
WASH, RINSE STATUS lights flash 1 time
Pressure Sensor Error
• The control has detected trouble sensing the water fill lev-
el.
• Unplug the machine and call for service.
RINSE, LID LOCK STATUS lights flash 3 times
Lid Open Error
• The control senses that the lid is open during a running cy-
cle.
• Unplug the machine to clear this code.
RINSE, LID LOCK STATUS lights flash 2 times
Lid Lock Error
• The control senses that the lid has unlocked during a run-
ning cycle.
• Unplug the machine to clear this code.
WASH, RINSE STATUS lights flash 2 times
No Water Flow Error
• The washer has not filled to the proper water level.
• No or very little change in water level has been sensed
within 5 minutes of the current fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
Table continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
23 Part No. 204101ENR1