800793
41
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
23. HEATER INDICATOR LIGHT (Models
equipped with heater)
a. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
b. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
c. Carefully remove bottom front of hood from
clips on cabinet top.
d. Disconnect two wires from heater indicator
light.
NOTE: Refer to wiring diagram when rewiring
light.
e. Refer to Figure 6 for light removal.
24. GRAPHIC PANEL
a. Unscrew timer knob from timer shaft (right
hand thread), then remove timer knob skirt.
Refer to Figure 6.
b. Pull temperature switch knob and signal control
knob off shafts.
c. Remove door lock and heater indicator light
lenses. Refer to Figure 6.
d. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
e. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
f. Carefully remove bottom front of hood from
clips on cabinet top.
g. Disconnect wires from components and
carefully remove components from control
mounting plate.
NOTE: Refer to wiring diagram when rewiring
component parts.
h. Remove extra rinse switch by pressing in on
locking tabs and push switch out through front
of graphic panel. Refer to Figure 6.
i. Remove screws holding both end panels to
control hood assembly. Refer to Figure 6.
j. Bend tabs on graphic panel (located inside of
control hood) straight out toward rear of hood.
k. Carefully remove graphic panel off front of
control mounting plate. Refer to Figure 6.
25. LOWER ACCESS PANEL
a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel. Refer to Figure 9.
b. Gently lower the access panel to disengage
panel locators from bottom edge of front panel.
Figure 9
FLW1646S
SCREW
LOWER
ACCESS
PANEL
