F238000
25
Section 4 Service Procedures
To reduce the risk of electrical shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer-extractor before servicing.
• Never start the washer-extractor with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer-extractor is properly grounded.
W171
WARNING
34. BELT
a. Remove screws holding rear panel to cabinet
and remove rear panel.
b. Use a piece of two-by-four or something
similar to support motor, refer to
Rotate pulley to run belt off pulley and motor.
Once belt has been removed from pulley, take
out support and lower motor gradually.
DO
NOT
let the motor drop or you could damage
the motor.
35. MOTOR
a. Remove screws holding rear panel to cabinet
and remove rear panel.
b. Insert key into cabinet top lock and turn
clockwise. Lift up on front of cabinet top until
it is just past the rear hinges, or 90 degrees, refer
to
. Lift cabinet top off machine and set
out of way.
NOTE: When reinstalling cabinet top, metal edges
on dispenser opening must be fitted inside of
dispenser.
c. Remove two T20 Torx head screws from
control module box cover. Lift up cover and set
aside.
d. Disconnect motor wire harness from contactors
in control module box.
NOTE: Disconnect ground wire before removing
motor.
e. Remove ground screw from frame, refer to
f. Use a piece of two-by-four or something
similar to support motor, refer to
Rotate pulley to run belt off pulley and motor.
g. Lower motor gradually.
DO NOT
let the motor
drop or you could damage the motor. Remove
tension spring from frame and motor, refer to
. Once spring has been removed, take
out support.
h. Remove inner cotter pin and drive motor shaft
out using a drift punch.
To reduce the risk of serious injury or
death, the rear panel MUST be installed
before operating the washer-extractor. The
rear panel keeps dust and dirt from
accumulating on motor, adds rigidity to
structure of the washer-extractor and
provides safety protection.
W266
WARNING
Figure 15
B014SE1A
GROUND
SCREW
TENSION
SPRING
INNER
COTTER
PIN
MOTOR
SUPPORT
ROD
SPACERS
