18
F238000
Section 4 Service Procedures
To reduce the risk of electrical shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer-extractor before servicing.
• Never start the washer-extractor with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer-extractor is properly grounded.
W171
WARNING
24. TIMER DELAY RELAY
IMPORTANT: When replacing the timer delay
relay assembly, do a wire-for-wire exchange, or
write down all the wire terminal connections before
removing any wires. If you have a problem, refer to
the wiring diagram on the underside of the cabinet
top.
a. Insert key into cabinet top lock and turn
clockwise. Lift up on front of cabinet top until
it is just past the rear hinges, or 90 degrees, refer
to
. Lift cabinet top off machine and set
out of way.
NOTE: When reinstalling cabinet top, metal edges
on dispenser opening must be fitted inside of
dispenser.
b. Remove two T20 Torx head screws from
control module box cover. Lift up cover and set
aside.
c. Remove nut and washer holding relay to
control module box.
d. Remove timer delay relay from control module
25. FLANGE RELAY
IMPORTANT: When replacing the flange relay
assembly, do a wire-for-wire exchange, or write
down all the wire terminal connections before
removing any wires. If you have a problem, refer to
the wiring diagram on the underside of the cabinet
top.
a. Insert key into cabinet top lock and turn
clockwise. Lift up on front of cabinet top until
it is just past the rear hinges, or 90 degrees, refer
to
. Lift cabinet top off machine and set
out of way.
NOTE: When reinstalling cabinet top, metal edges
on dispenser opening must be fitted inside of
dispenser.
b. Remove two T20 Torx head screws from
control module box cover. Lift up cover and set
aside.
c. Remove two screws holding relay to control
module box.
d. Remove flange relay from control module box,
Figure 7
B007SE1A
TIMER DELAY
RELAY
FLANGE
RELAY
