Alliance Laundry Systems HC18, Предварительное руководство по обслуживанию

Страница: 29 / 31

F238000
29
Section 4 Service Procedures
To reduce the risk of electrical shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer-extractor before servicing.
• Never start the washer-extractor with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer-extractor is properly grounded.
W171
WARNING
40. CYLINDER ASSEMBLY
a. Insert key into cabinet top lock and turn
clockwise. Lift up on front of cabinet top until
it is just past the rear hinges, or 90 degrees, refer
to
Figure 1 . Lift cabinet top off machine and set
out of way.
NOTE: When reinstalling cabinet top, metal edges
on dispenser opening must be fitted inside of
dispenser.
b. Remove two T20 Torx head screws from
control module box cover. Lift up cover and set
aside.
c. Remove screws holding rear panel to cabinet
and remove rear panel.
41. TRUNNION ASSEMBLY
a. Insert key into cabinet top lock and turn
clockwise. Lift up on front of cabinet top until
it is just past the rear hinges, or 90 degrees, refer
to
Figure 1 . Lift cabinet top off machine and set
out of way.
NOTE: When reinstalling cabinet top, metal edges
on dispenser opening must be fitted inside of
dispenser.
b. Remove screws holding rear panel to cabinet
and remove rear panel.
c. Remove belt.
NOTE: Support motor to avoid shaft damage.
d. Remove center bolt, refer to Figure 21 .
e. Remove drive pulley, refer to Figure 21 .
f. Remove shaft key, refer to Figure 21 .
g. Remove trunnion locknuts, refer to Figure 21 .
Figure 21
B026SE3A
CENTER
BOLT
TRUNNION
LOCKNUT
DRIVE
PULLEY
SHAFT
KEY