802643
55
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
34. Washer Door Catch
NOTE: When repairing a broken or inoperative No.
802803 Door Catch, proceed as follows:
a. Open loading door.
b. Remove 11 T-20 Torx head screws holding
outer door bezel to inner door bezel. Refer to
Figure 6
.
c. Pull hinge side of outer bezel away from door
and slide forward. Refer to
Figure 6
.
d. Remove two screws and nuts holding door
catch to door and remove door catch.
e. Install new door catch and tighten screws and
nuts to the point of being snug.
f. Adjust door catch so the outside edge is
aligned with the edge of the lock. Refer to
Figure 7
.
g. Visually check that the door catch properly
engages the funnel of the door latch/switch
assembly. Refer to
Figure 7
.
h. Recheck the alignment in step “f”. Adjust if
needed.
i. Torque the two nuts to approximately 20 inch
pounds (2.25 Nm).
j. Reinstall outer door bezel by aligning outer
bezel tabs with cut aways on inner bezel and
sliding outer bezel into position. Refer to
Figure 6
.
k. Replace 11 screws holding outer door bezel to
inner door bezel.
IMPORTANT: Do not overtighten screws or bezel
holes will strip.
Figure 6
FLW1777S
Outer Bezel
Tab
Inner Bezel
Cut Away
Содержание CTSA7AWN
Страница 2: ......
